Saillogger Community

Yep, very awkward. An I did a factory reset on Cerbo GX many times and tried with minimal configuration parameters and firmware update. At Signal K Server, just security config, nmea 2000 connection and derived data plugin and always same error. So last resource was to dig at logs with AI and that whtas solved.

Hello there. After logs analysis, Python update solved the issue.
SH at Cerbo and run this commands:
opkg update
opkg install python3-pip

Take more than 1 hour but worked fine.
Thanks

Let me know if this helps:

Update: Did a clean install on Cerbo GX, Updated to 3.60 firmaware Version. Started Signal K Server. Just configure user privileges and tried to install only Saillogger. Get the same Failed message.

Installing:

And Failed after 2/3 minutes:

Hi @admin, the process to create a clean SignalK Server works perfect.
Just after I tried to install Saillogger plugin, and after 2 or 3 minutes it failed. Same as before.. Any place else I should remove something? Thanks.

Hi. Trying to install SailLogger on CerboGX/Signal K server but with no success. Failed message.
Servers already rebooted. At first try when SailLogger was been installed, the server was rebooted and now always failed. Is there any way to clean the last installation try, by SSH or other way?
Thank you.