Installation Problem

[admin]

Hi @Gerler , you can create a fresh installation of Signal K using SSH. Please see this thread for more details.

[Gerler]

Hi @admin, the process to create a clean SignalK Server works perfect.
Just after I tried to install Saillogger plugin, and after 2 or 3 minutes it failed. Same as before.. Any place else I should remove something? Thanks.

[admin]

That's odd, what is the error message you are seeing?

[Gerler]

Installing:

And Failed after 2/3 minutes:

[Gerler]

Update: Did a clean install on Cerbo GX, Updated to 3.60 firmaware Version. Started Signal K Server. Just configure user privileges and tried to install only Saillogger. Get the same Failed message.

[Gerler]

Let me know if this helps:

[Gerler]

[Gerler]

Hello there. After logs analysis, Python update solved the issue.
SH at Cerbo and run this commands:
opkg update
opkg install python3-pip

Take more than 1 hour but worked fine.
Thanks

[admin]

Ok, glad it is solved but this is super awkward, Saillogger plugin has absolutely nothing to do with Python. There must be something else happening in the system, but not sure what it might have been.

[Gerler]

Yep, very awkward. An I did a factory reset on Cerbo GX many times and tried with minimal configuration parameters and firmware update. At Signal K Server, just security config, nmea 2000 connection and derived data plugin and always same error. So last resource was to dig at logs with AI and that whtas solved.